Ohio Game Fishing banner

1 - 2 of 2 Posts

·
Lake Erie Charter Captain
Joined
·
630 Posts
Discussion Starter · #1 ·
Been trying to figure out my tilt problem on my stinger outdrive, well, Pulled out the motor, it was running pretty good. Decided to clean the armature and brushes. That is were I found the problem. Split the housing and out poured about 1/4 cup of oil...... must of came up the tilt gear housing.

Any one have this issue before or knows a good way to clean the oil out of the windings and armature?

I beleive the motor is fine just not good connection on comutater and brushed because of the oil.


Any help would be great.

Larry
 

·
ORIGINAL TEAM OGF
Joined
·
5,509 Posts
Go to Napa and get a spray can of Electrical Contact cleaner.
It wont harm the windings,but it will flash...its flammable.
Just make sure it is evaporated before you try the motor.
 
1 - 2 of 2 Posts
Top